Addressing the indoor unit AG-WT10
Addressing via remote control
When addressing using remote control it is possible to connect up to eight indoor units to one outdoor unit.
Set the remote control according to the table below, direct it towards the desired indoor unit and keep the buttons
"FAN" and "iFEEL" pressed for more than five seconds. If the unit has received the command, four beeps are sounded
as confirmation. When you have heard the peeps, the unit starts to work with the new address.
Indoor unitButton
HGFEDCBA
AUTO
Operating mode ( or )
18 °C17 °C16 °C15 °C14 C13 °C12 °C11 °CSet point temperature
( / )
AUTO
Air deflector ( )
ON
Air filter ( )
OFF
Night program ( )
OFF
High power ( )
Addressing via DIP switches
When addressing using DIP switches it is possible to connect up to four indoor units to one outdoor unit. Set SW1
as indicated in the table.
Indoor unit
DCBA
21Chapter 5 | InstallationAG-AC10
To Next Page
Loading...
