Speed control - Heating
Alternatives: Auto/manual
Manual
Alternatives: On/Off
Speed in standby mode
Setting range: 1 – 100%
Speed control - Pool
Manual
Alternatives: On/Off
Manual speed Pool
Setting range: 1 – 100%
Speed control - Hot water
Manual
Alternatives: On/Off
Manual speed Hot water
Setting range: 1 – 100%
Speed control charge pump - Cooling
Manual
Alternatives: On/Off
Active cooling.
Setting range: 1 – 100%
Lowest permitted speed
Setting range: 1 – 50%
Highest permitted speed
Setting range: 80 – 100%
Speed control : Here, you set whether the charge pump
will be regulated automatically or manually. Select "Auto"
for optimal operation.
Speed in standby mode: Here, you set the speed the
charge pump will have in standby mode. Standby mode
occurs when heating or cooling operation is permitted
at the same time as there is no need for either com-
pressor operation or electric additional heat.
Speed control charge pump: Here, you set whether the
charge pump is to be regulated automatically or via
manually controlled speed. Select "Auto" for optimal
operation.
Manual speed, charge pump: If you have opted to con-
trol the charge pump manually, you set the desired
pump speed here. (Settings are available per demand
heating/pool/hot water/cooling.)
Lowest permitted speed: Here, you can restrict the
pump speed, so the charge pump is not allowed to op-
erate at a lower speed than the set value.
Maximum permitted speed: Here, you can restrict the
pump speed, so the charge pump is not allowed to op-
erate at a higher speed than the set value.
AXC 30 S-series | GB36
S
To Next Page
Loading...
Need help?
General