affect room temperature
Here you set whether room temperature should be affected when activat-
ing "SG Ready".
With low price mode of "SG Ready" the parallel offset of the indoor tem-
perature is increased by "+1". If a room sensor is installed and activated,
the desired room temperature increases by 1 °C.
With over capacity mode of "SG Ready" the parallel offset for the indoor
temperature is increased by"+2". If a room sensor is installed and activated,
the desired room temperature increases by 2 °C.
affect hot water
Here you set whether the temperature of the hot water should be affected
when activating "SG Ready".
With low price mode on "SG Ready" the stop temperature of the hot water
is set as high as possible at only compressor operation (immersion heater
not permitted).
With over capacity mode of "SG Ready" the hot water is set to "luxury"
(immersion heater permitted).
NOTE
The function must be connected and activated in your F750.
NIBE™ F750Chapter 3 | F750 – at your service60
To Next Page
Loading...
