What to do if I get a sensor fault for the BT1 outdoortemperature sensor on my Nibe F1245?
If the input for the BT1 outdoortemperature sensor on your Nibe Heat Pump receives an unreasonably high or low value for more than 2 seconds, refer to the fault-tracing schedule on page 37.
What to do if I get a sensor fault for the BT2 supplytemperature sensor 1 on my Nibe F1245?
If the input for the sensor BT2 supplytemperature sensor 1 on your Nibe Heat Pump receives an unreasonably high or low value for longer than 2 seconds, consult the fault-tracing schedule on page 38.
What to do if there is a sensor fault with AZ1- BT20 on my Nibe F1245 Heat Pump?
If there is a sensor fault with AZ1- BT20 on your Nibe Heat Pump because the sensor is not connected or defective (exhaust air), refer to the fault-tracing schedule on page 40.
What to do if there is a sensor fault with AZ1- BT21 on my Nibe Heat Pump?
If there is a sensor fault with AZ1- BT21 on your Nibe Heat Pump because the sensor is not connected or defective (extract air), refer to the fault-tracing schedule on page 40.
What to do if I get a sensor fault for the BT11 brine out on my Nibe Heat Pump?
If the input for the BT11 brine out sensor on your Nibe Heat Pump receives an unreasonably high or low value for longer than 2 seconds, refer to the fault-tracing schedule on page 39.
What to do if I get a sensor fault for the BT12 condenser out on my Nibe F1245?
If the input for the BT12 condenser out sensor on your Nibe Heat Pump receives an unreasonably high or low value for longer than 2 seconds, refer to the fault-tracing schedule on page 39.
What to do if there is a sensor fault with AZ1- BT26 on my Nibe F1245?
If there is a sensor fault with AZ1- BT26 on your Nibe Heat Pump because the sensor is not connected or defective (brine, collector in), refer to the fault-tracing schedule on page 40.
What to do if there is a sensor fault with BT3 return line sensor 1 on my Nibe Heat Pump?
If there is a sensor fault with BT3 return line sensor 1 on your Nibe Heat Pump because the sensor is not connected or defective (heating medium return), refer to the fault-tracing schedule on page 39.
What to do if there is a sensor fault with BT10 brine in on my Nibe F1245?
If there is a sensor fault with BT10 brine in on your Nibe Heat Pump because the sensor is not connected or defective (brine in), refer to the fault-tracing schedule on page 39.
General| Refrigerant | R410A |
|---|---|
| Control System | NIBE SMO 40 |
| Dimensions (HxWxD) | 1800 x 600 x 620 mm |
| Energy Efficiency Class Heating 35°C | A++ |
| Energy Efficiency Class Heating 55°C | A++ |
| Heating Capacity | 5-12 kW |
| COP Heating | 4.5 |
| Integrated Hot Water Tank | 180 liters |
| Power Input Heating | 1.0 - 3.0 kW |
To Next Page
