To reduce energy consumption during
a holiday you can schedule a reduc-
tion in heating, ventilation and hot
water temperature. Solar panel cool-
ing can also be scheduled if the func-
tion is connected.
If a room sensor is installed and activ-
ated, the desired room temperature
(°C) is set during the time period. This
setting applies to all climate systems
with room sensors.
Menu
4.7
If a room sensor is not activated, the desired offset of the heating curve is
set. One step is usually enough to change the room temperature by one
degree, but in some cases several steps may be required. This setting applies
to all climate systems without room sensors.
Vacation scheduling starts at 00:00 on the start date and stops at 23:59
on the stop date.
TIP
Complete holiday setting about a day before your return so that room
temperature and hot water have time to regain usual levels.
TIP
Set the vacation setting in advance and activate just before departure
in order to maintain the comfort.
NIBE™ F750Chapter 3 | F750 – at your service64
To Next Page
Loading...
