General
RPP 10 is a wireless outlet that amplifies the signal between
zones and improves the communication between your smart
home products, if they are located a long way from the main
product. RPP 10 has a built-in energy meter and continu-
ously reports the energy consumption to your main product.
NOTE
If RPP 10 loses contact with the main product,
RPP 10 will try to reconnect for 60 minutes, if the
reconnection fails, the power supply to the output
socket in RPP 10 will be turned off. Therefore, do
not connect equipment that is sensitive to power
outages.
MAXIMUM LOAD
You can connect a maximum of 2,990W/13A to RPP 10.
FUNCTIONS
Caution
RPP 10 requires the main product to have software
version 2.0 or later. The "Scheduling" function re-
quires software version 2.1.
MANUAL CONTROL
There is a built-in function that allows you to control RPP 10
by remote control. Using the remote control function, you
can turn the power outlet in RPP 10 on and off manually via
the app on your smartphone and on myuplink.com. Alternat-
ively, you can turn the power outlet on and off using the
physical button on RPP 10.
ENERGY METER
The energy consumption for products connected via the
power outlet in RPP 10 is measured and reported. The
measured value can be presented in two ways:
• Current consumption (W)
• Total consumption (kWh)
SCHEDULING
RPP 10 can be controlled via your main product’s scheduling.
In the main product, you follow a guide for scheduling the
power outlet in RPP 10 to control the times at which the
current is to be turned on and off.
COMPATIBLE PRODUCTS
• VVM S320• S1155/S1255
• VVM S325• SMO S40
CONTENTS
RPP 101 x
Quick guide1 x
RPP 10 | EN10
To Next Page
Loading...