20 – English
EN
TECHNICAL CHARACTERISTICS OF THE
PRODUCT
■ Power supply:
WS and WSR: 100–240 V AC, 50/60 Hz
WSC: autonomous solar power with 100 mWp pho-
tovoltaic cell
■ Frequency: 433.92 MHz with integral antenna
■ Radiated power(*):
WS and WSR: approx. 4.5 mW (erp).
WSC: approx. 0,5 mW (erp).
In optimal conditions this corresponds to a range of
approx. 100 m in open eld or 20 m inside buildings.
■ Protection rating(**): IP55
■ Operating temperature:
WS and WSR: - 20°C to + 60°C
WSC: - 10°C to + 60°C
■ Dimensions mm: (volume) 114 x 225 x 85 (H)
■ Number of motors that can be combined:
MOMODIRECTIONAL motors: no limits
BIDIRECTIONAL Motors: 2 motors
• “Sun” sensor
■ Range: 0 to 83 klux
■ Threshold: 5 to 60 klux
• “Rain” sensor (WSR only)
■ Range: Presence / absence of drops of water
• “Wind” sensor
■ Range: 10 to 120 kph
■ Threshold: 20 to 100 kph
NOTES ON TECHNICAL SPECIFICATIONS:
• (*) The transmitter's range may be affected by other
devices operating nearby and at the same frequency
(e.g. wireless headsets, alarm systems, etc.), which
interfere with it. In the event of strong interference,
Nice cannot guarantee the effective range of their de-
vices.
• (**) WS and WSR: Only the correct installation of
the cable in the seal and tightening the cable cover
screws ensures proper sealing of the device.
• All technical specifications stated herein refer to an
ambient temperature of 20° C (± 5° C).
• The device is equipped with an NFC module. For
more information, please contact the support.
• Nice S.p.A. reserves the right to apply modifications
to the product at any time when deemed necessary,
maintaining the same intended use and functionality.
EU DECLARATION OF CONFORMITY
Hereby, NICE S.p.A., declares that the radio equip-
ment types Domi WS, Domi WSC and Domi WSR
are in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conform-
ity is available at the following internet address:
http://www.niceforyou.com/en/support
PRODUCT DISPOSAL
• This product is an integral part of the automation
and must therefore be scrapped together with it, in the
same way as indicated in the automation's instruction
manual. • Dispose of the product packaging material in
compliance with established local legislation.
To Next Page
Loading...
