English – 7
EN
08. Three beeps are emitted if the operation has been
successful otherwise 5 rapid beeps are given
indicating that one of the steps was unsuccessful
Note: If one wishes to use DS100 without having to introduce a combination, a combination
with no numbers can be introduced by not pushing the buttons at points 04 and 06 of table 2.
If the combination is forgotten it can be changed by repeating the above
mentioned points and entering at point 02 of the procedure the special
default “PUK code” in place of the current combination.
Each DS100 has its own individual 10 digit “PUK” code which can be found
on the front cover of this manual.
To Next Page
Loading...
Need help?
General
