EasyManuals Logo

Nice E EDGE SI 228 LI ION User Manual

Nice E EDGE SI 228 LI ION
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
A.5 - Memorising ANOTHER TRANSMITTER (second, third, etc.)
NOTES AND WARNINGS
To run procedures A.5.1.A and A.5.2.A, you must have a new transmitter to memorise and an old previously memorised transmitter. The two transmitters must
have the “PRG” and “ESC” buttons (like “ERA P” and “ERA W” transmitters).
To run procedures A.5.1.B and A.5.2.B you must have a new transmitter to memorise, chosen from the “Nice Screen” catalogue , and an old previously memorised
transmitter.
A.5.1 - To memorise the transmitter buttons in “Mode I” (“Standard mode”)
Procedures A.5.1A and A.5.1.B memorise all the new transmitter’s buttons in “Mode I”, with the same configuration as the old transmitter (for details about “Mode
I” see par. 3.4.1-A).
A.5.1.A - Procedure for transmitters equipped with the “PRG” and “ESC” buttons (“ERA P” and “ERA W”)
1
2
OLD
PRG
...
2
1
sec.
2
PRG
On the OLD transmitter: hold down the
button and
wait ... count 2 movements; wait again... count 2 more move-
ments;
release the button.
2 3
end
NEW
PRG
= 5 sec
PRG
2
OLD
PRG
(x 1)
On the NEW transmitter: hold down
the button and
release it after 5
seconds;
count 2 movements. On the OLD transmitter: press and
release the button (1 time);
count 3 movements (= transmitter
memorised). If the system makes 6
movements (= memory locked or full,
transmitter not memorised).
A.5.1.B - Procedure for transmitters without the “PRG” and “ESC” buttons”
1 2
3
NEW
= 8 sec
OLD
(x 3)
On the NEW transmitter: hold down the but-
ton and
release it after 8 seconds; On the OLD transmitter: press and release the but-
ton (3 times), provided the button is memorised.
3
end
NEW
(x 1)
3
On the NEW transmitter: press and re-
lease the button (1 time);
count 3 movements (= transmitter memorised). If
the system makes 6 movements (= memory locked or
full, transmitter not memorised).
A.5.2 - To memorise the transmitter buttons in “Mode II” (“Custom mode”)
Procedures A.5.2A and A.5.2.B memorise a single button on the new transmitter in Mode II; i.e. they associate with the button (chosen by the installer) one of the
commands in the motor’s “list of commands” (for details on “Mode II” see section 3.4.1-B).
• Procedures A.5.2A and A.5.2.B memorise a single button. Repeat this operation to memorise another button.
A
9 – English

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nice E EDGE SI 228 LI ION and is the answer not in the manual?

Nice E EDGE SI 228 LI ION Specifications

General IconGeneral
BrandNice
ModelE EDGE SI 228 LI ION
CategoryEngine
LanguageEnglish

Related product manuals