A.5.2.A - Procedure for transmitters equipped with the “PRG” and “ESC” buttons (“ERA P” and “ERA W”)
1 2
continues
OLD
PRG
1
sec.
PRG
NEW
PRG
= 5 sec
On the OLD transmitter: Hold
down the button and wait...
count 2 movements; wait
again...
count 2 more move-
ments;
release the but-
ton.
On the NEW transmitter: hold down the but-
ton and
2
3
continues
PRG
Select the desired
option and pro-
gram it
as follows
OLD
(x ...)
8 OPTIONS:
1 press = Open > Stop > Close > Stop > ...
2 presses = Open
3 presses = Close
4 presses = Stop
5 presses = Open after 10 seconds
7 presses = Open after 20 seconds
8 presses = Close after 10 seconds
9 presses = Close after 20 seconds
release it after 5 seconds; count 2 movements.
On the OLD transmitter: Press and release the button the number of times indicated
in the option you have chosen;
3
4
end
7
sec.
n
NEW
= 5 sec
...
After about 7 seconds, the motor performs a
number of movements equal to the number
of pulses entered.
On the NEW transmitter: select the button
you want to memorise; hold it down and
release it after 5
seconds;
count 3 movements (= transmitter memo-
rised). If the system makes 6 movements (= mem-
ory locked or full, transmitter not memorised).
A.5.2.B - Procedure for transmitters without the “PRG” and “ESC” buttons”
• When performing the procedure, you can cancel the programming at any time by holding down n and t together for 4 seconds. Alternatively, do not press any keys
and wait 60 seconds for the motor to perform 6 movements.
1 2
3
NEW
...
OLD
On the NEW transmitter: hold down the but-
ton you want to memorise;
release it after 8 sec-
onds;
On the OLD transmitter: hold down the
button and
release it after 5
seconds;
count 4 movements.
3
continues
Select the desired
option and program
it as follows
OLD
(x ...)
8 OPTIONS:
1 press = Open > Stop > Close > Stop > ...
2 presses = Open
3 presses = Close
4 presses = Stop
5 presses = Open after 10 seconds
7 presses = Open after 20 seconds
8 presses = Close after 10 seconds
9 presses = Close after 20 seconds
On the OLD transmitter: press and release the button the number of times indicated in the option you have chosen;
3
4
end
7
sec.
n
NEW
= 5 sec
...
After about 7 seconds, the motor performs a
number of movements equal to the number of
pulses entered.
On the NEW transmitter: hold down the
same button you pressed in Step 1;
release it after 5
seconds;
count 3 movements (= transmitter memo-
rised). If the system makes 6 movements (= mem-
ory locked or full, transmitter not memorised).
English – 10
To Next Page
Loading...
Need help?
General
