Nice E FIT M 817 BD

B.1 - Memorising ANOTHER TRANSMITTER (second, third, etc.)
BiDi
NOTES AND WARNINGS
• The motor configured to operate in TWO-WAY mode can memorise up to 16 transmitters.
• To run procedures B.3 you must have a new transmitter to memorise and an old previously memorised transmitter. The two transmitters must have the “PRG” and
“ESC” buttons (like “ERA P” and “ERA W” transmitters).
• Procedures B.3 memorise all the new transmitter’s buttons in “Mode I”, with the same configuration as the old transmitter (for details about “Mode I” see par. 4.6.1).
1 2
 3
OLD
PRG
(x 1)
2
NEW
= 5 sec
2
On the OLD transmitter: Press
and release the button (1 time);
count 2 movements; On the NEW transmitter: hold
down the button and
release it after 5 sec-
onds;
count 2 movements;
3 4
end
OLD
PRG
(x 1)
2
NEW
(x 1)
3
On the OLD transmitter: Press
and release the button (1 time);
count 2 movements; On the NEW transmitter: Press
and release the button (1 time);
count 3 movements
(= transmitter
memorised).
B
B.1 - Temporarily deactivating (and reactivating) motors you do not wish to program
BiDi
NOTES AND WARNINGS
• This procedure temporarily deactivates (for 5 minutes) only motors whose up and down limit switches have already been programmed.
B.2.1 - To temporarily deactivate motors you do not wish to program
1 2
end
ESC
= 5 sec
ESC
“0”
The system locks out only those motors whose limit
switches have already been programmed. It has no ef-
fect on motors which have not yet been programmed.
The deactivation is temporary and lasts for 5 min-
utes.
Hold down the but-
ton and
release it after 5 sec-
onds;
you will see a brief down
movement and a movement
which stops the awning at
the Up limit “0”.
For a period of 5 minutes, the locked out motors will not
respond to commands.
B.2.2 - To reactivate temporarily locked out motors
You can reactivate the motors in two ways:
option – A
1
end
option – B
1
end
After 5 minutes the
locked out motors are
automatically reactivat-
ed by the system.
During the 5 minute
period the locked out
motors can be reacti-
vated at any time by the
user.
ESC
= 10 sec
ESC
Wait for 5 minutes ... ... the system will then
move the awning to
the mid position.
During the 5 minutes, at
any time...
... hold down the
button and
release it after 10
seconds;
the system will then
move the awning to
the mid position.
B
English – 14