Nice E FIT M 817 BD

B.4 - TOTAL or PARTIAL deletion of memory
BiDi
NOTES AND WARNINGS
• In order to carry out the following deletion procedures, the transmitter must be memorised in mode I.
• To change the motor’s configuration (from TWO-WAY to ONE-WAY), after completing the “FULL deletion of the memory” procedure, it is necessary to switch the mo-
tor off and then on again.
• Once the transmitter has been deleted from the motor’s memory, it is necessary to delete from the transmitter’s memory the motor that is no longer
associated, to prevent “no motor” error messages from appearing on the transmitter (refer to the transmitter manual).
B.4.1 - Procedure run with a memorised transmitter
1 2 3
 4
PRG
(x 1)
2
PRG
(x 1)
2
PRG
(x 1)
3
Press and release
the button (1 time);
count 2 movements. Press and release
the button (1 time);
count 2 movements. Press and release
the button (1 time);
count 3 movements.
4 5
...
PRG
(x 1)
4
Select one of the following potions and execute it:
• option A (*) – delete the motor’s ENTIRE memory
• option B (*) – delete ALL memorised transmitters
• option C (*) – delete ONE memorised transmitter
• option D (*) – delete ALL positions (“0”, “1”, “H”, etc.). Caution! – This deletion should only be performed if you wish re-
program the distances using a procedure different from the one used previously (e.g. you have used manual distance pro-
gramming (C.1) and would now like to use the semi-automatic procedure (C.2).
(*) Warning! – Once the procedure relative to the chosen option (A, B, C or D) has been completed, perform the
dissociation procedure for the two-way remote control (refer to the instructions of the two-way remote con-
trol).
Press and release
the button (1 time);
count 4 movements.
option – A
5
end
option – B
5
end
PRG
(x 1)
5
= 5 sec
5
Press and release the
button (1 time);
count 5 movements. Hold down the button and release it after 5 seconds; count 5 movements.
option – C
5 6
end
= 5 sec
3
= 5 sec
5
Hold down the but-
ton and
release it after 5
seconds;
count 3 movements. On the transmitter to be deleted: hold down any
key either the key memorised in mode 2 or the cli-
matic conditions sensor;
count 5 movements.
option – D
5
end
= 5 sec
5
Hold down both buttons... release them after 5
seconds;
count 5 movements.
B
15 – English