4
ON/OFF This key is for switching the TTP on and off, and searching for the connected motor.
OPEN Sends the ‘Open’ command (‘Up’ for awnings).
This key is the equivalent of the ‘Open’ key on the remote control.
STOP Sends the ‘Stop’ command.
This key is the equivalent of the ‘Stop’ key on the remote control.
CLOSE Sends the ‘Close’ command (‘Down’ for awnings).
This key is the equivalent of the ‘Close’ key on the remote control.
OK This key is for confirming all programming operations; the three LEDs associated with this
key indicate the status of the operations in progress or of the communication between TTP
and motor.
ANTICLOCKWISE Programmes anticlockwise motor rotation.
CANCEL DIRECTION Cancels the settings for the direction of motor rotation.
CLOCKWISE Programmes clockwise motor rotation.
TORQUE REDUCTION Enables/disables the torque reduction (RDC) function.
POSITION “0” Memorises position “0”.
POSITION “1” Memorises position “1”.
INTERMEDIATE POSITION Memorises intermediate position “I”.
POSITION 0 AND 1 Starts the automatic search procedure for positions “0” and “1”.
AUTOMATIC SEARCH
WIND THRESHOLD
Displays and modifies the intervention threshold of the wind protection. Pressing the key repeatedly,
enables you to move cyclically through all the thresholds permitted by the connected motor
SUN THRESHOLD
Displays and modifies the intervention threshold of the sun protection. Pressing the key repeatedly,
enables you to move cyclically through all the thresholds permitted by the connected motor
RAIN DIRECTION Displays and changes the direction of movement if the rain sensor is triggered.
SENSORS ON/OFF Enables/disables intervention of the automated sun and rain systems
CANCEL PARAMETERS Cancels the parameters of the motor and restores the factory settings.
MEMORIZE Memorizes a radio control in the motor memory.
RADIO CONTROLS
CANCEL RADIO Cancels a radio control from the motor.
CONTROLS
3.2) Keypad
The appearance of the keypad of the TTP programmer is as shown in Figure 3. The keypad symbols and their meaning are described in
Table 2.
Table 2 Key Description
3
To Next Page
Loading...
Need help?
General