NICEDAY CT11 - Digital Monitor Instructions: Additional Features; Additional Modes and Operations

5.CAL: Count the total calories for the whole exercise period.
6.ODO: Count the total distance within one battery capacity running period.
7.PULSE:
(1 ) Measure the current pulse.
(2) Press the MODE button to turn to PULSE mode. Place your palms on both of the contact
pads. The monitor will show the current heartbeat rate in beats per minute(BPM) on the LCD
after 6-7 seconds.
’"Remark: During the process of pulse measurement, the measurement value may be higher
than the actual pulse rate in the first 2-3 seconds due to contact jamming, then will recover to
the exact level. The measurement value cannot reference for medical treatment.
Other Instructions for The Digital Monitor
1. ALARM: The monitor will “Beep” when press the“MODE”, “SET”, and “RESET” buttons
together.
2.AUTO ON/OFF &AUTO START/STOP: The power will turn off automatically if receive no
signal for 4 minutes. As long as the rockers are in motion status or press any buttons, the
monitor will be in working status.
3.Cumulative Data: The monitor will stop counting when the pedals stop running. The data will
be auto cumulative. If you need to recount data, short-press the RESET button to reset a single
data, and extended-press the RESET button to reset all data.
-10-