NICOR Prime Chime Plus - User Manual

NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com May 29, 2020 4:02 PM PRCP2 Rev - Page 1 of 4
What’s In The Box
One (1) Prime Chime Plus Two (2) Lighted Doorbell Buttons
Prime Chime Plus
INSTALLATION INSTRUCTIONS
Model:
PRCP2
Tools Needed
The Prime Chime Plus requires very few tools for installation. A screwdriver and a pair of wirecutters will be
required to install the chime.
WARNING - RISK OF SHOCK
1. This xture is to be installed by only a qualied electrician.
2. This xture is to be used at 120V AC/60Hz power supply only.
3. This xture is designed for use in a circuit protected by a fuse or circuit breaker.
4. Turn o the power supply at the fuse or circuit breaker box before you install this xture.
5. Turn o the power supply again when you perform maintenance.
6. Double check all connections to be sure they are all tight and correct.
7. Operation environment: to be installed indoors under dry and ventilated environment. It should NOT be installed damp locations or
environment with high temperature. Installation of this xture should be kept away from other electrical devices.
One (1) Hardware Pack
Junction Box
Pre-install a dual voltage box (CARLON Model#SC200DV or equivalent, not provided) before installation of this device.
Video Doorbell Compatibility Notes
For all video doorbells:
1) To ensure proper operation of the PRCP2, no more than one video doorbell should be attached (Front Door or Back Door)
2) Make sure the video doorbell is fully charged prior to installation. Low battery levels may cause abnormal performance of the PRCP2.
3) Wiring must not exceed the following: 70’ from doorbell to rst unit. 200’ total length if installing more than one PRCP2
For Ring products:
1) Adjust the “Ring tone length” in the App to 2 seconds to avoid multiple chime cycles (see Ring instructions for details).
2) The Ring Power Kit (diode) should not be installed when using the NICOR PRCP2

Summary

General Safety Warnings

Electrical Safety Precautions

Essential safety precautions for installation and operation, including qualified electrician requirement and power shutoff.

Single Chime Installation

Connect Line Voltage Wiring

Connect the 120V AC/60Hz power supply to the chime's line voltage terminals.

Connect Low Voltage Bell Wires

Connect the low voltage doorbell wires to the chime's designated terminals.

Mount Chime to Junction Box

Attach Faceplate

Install Doorbell Button

Apply Power and Test

Apply power, check button illumination, and test chime functionality.

Multiple Chime Installation

Connect Line Voltage (Multiple)

Connect line voltage wiring to each chime unit per the diagram.

Connect Low Voltage (First Unit)

Connect Multiple Chimes

Connect bell wiring between chime units for multi-unit installations (max 2 units).

Mount Chimes to Junction Box

Attach Faceplates (Multiple)

NICOR Prime Chime Plus Specifications

General

Number of Chimes	1
Volume Control	Yes
Type	Wireless Doorbell
Function	Alerts homeowners when someone is at the door
Operating Range	Up to 500 feet