Nidec MCE Motion 2000 TS - HC-MPU-2-TS; Solid State Starter

Troubleshooting Reference
Manual # 42-02-1P28 A3 5-45
5
HC-MPU-2-TS
The HC-MPU-2-TS board provides system logic and control. The touchscreen is mounted on
this board
Figure 5.8 HC-HPU-2-TS
Solid State Starter
The solid state starter is the interface between the controller and the pump motor. The starter is
compatible with 3/6 or 9/12 lead motors. The connections between the starter and the motor
are shown in the prints for the particular job.
The Motion 2000 TS controller will display fault conditions related to the starter. When a
starter-related fault is displayed on the controller, the related fault condition is probably dis-
played on the starter LCD as well.
Danger
Always observe safety precautions when working with starter wiring. Lethal voltages are
present.
CPU-B
Reset