Need help?Do you have a question about the Nidec Unidrive M200 and is the answer not in the manual?
Critical warnings about electrical hazards including AC supply and stored charge.
Detailed listing of basic parameters in Menu 0 with their ranges and defaults.
Basic control connection requirements for running the motor in different modes.
Step-by-step guide for commissioning and starting the motor.
Explanation of motor map parameters for open loop and RFC-A control modes.
Details on parameter ranges and how minimum/maximum values vary.
Information on how trips are indicated and displayed on the drive.
Comprehensive list of trips, their sub-trip numbers, and diagnosis.
General| Series | Unidrive M200 |
|---|---|
| Overload | 150% for 60 seconds |
| Switching Frequency | 2 kHz to 16 kHz |
| Digital Output | 1 |
| Braking Resistor | Optional |
| Enclosure | IP20 |
| Product Type | Variable Frequency Drive |
| Control Method | V/f |
| Digital Inputs | 6 |
| Analog Inputs | 2 |
| Analog Output | 1 |
| Communication Protocols | Modbus RTU |
| Protection | Overcurrent, Overvoltage, Undervoltage, Overload, Overtemperature, Short Circuit |
| Operating Temperature | -10°C to +50°C |
| Humidity | Up to 95% RH, non-condensing |
To Next Page
