Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running the
motor
Optimization
NV Media
Card
Onboard
PLC
Advanced
parameters
Diagnostics UL Listing
70 Unidrive M200 / M201 Control User Guide
Issue Number: 2
11.1 Parameter ranges and Variable minimum/maximums:
Some parameters in the drive have a variable range with a variable minimum and a variable maximum value which is dependent on one of the
following:
• The settings of other parameters
• The drive rating
• The drive mode
• Combination of any of the above
The tables below give the definition of variable minimum/maximum and the maximum range of these.
Thermal protection - drive 05.018 05.035 07.004 07.005 07.035 10.018
Thermal protection - motor 04.015 05.007 04.019 04.016 04.025 08.035
Thermistor input 07.046 07.047 07.048 07.049 07.050 08.035
Threshold detector 1 12.001 12.003 to 12.007
Threshold detector 2 12.002 12.023 to 12.027
Time - filter change 06.019 06.018 06.021 06.022 06.023
Time - powered up log 06.020 06.019 06.017 06.018 06.084
Time - run log 06.019 06.017 06.018 06.084
Torque 04.003 04.026 05.032
Torque mode 04.008 04.011
Trip detection 10.037 10.038 10.020 to 10.029
Trip log 10.020 to 10.029 10.041 to 10.060 10.070 to 10.079
Under voltage 05.005 10.016 10.015 10.068
V/F mode 05.015 05.014
Variable selector 1 12.008 to 12.016
Variable selector 2 12.028 to 12.036
Voltage controller 05.031
Voltage mode 05.014 05.017 05.015
Voltage rating 11.033 05.009 05.005
Voltage supply 06.046 05.005
Warning 10.019 10.012 10.017 10.018 10.040
Zero frequency indicator bit 03.005 10.003
Features Related parameters (Pr)
VM_AC_VOLTAGE Range applied to parameters showing AC voltage
Units V
Range of [MIN] 0
Range of [MAX] 0 to 930
Definition
VM_AC_VOLTAGE[MAX] is drive voltage rating dependent. See Table 11-4
VM_AC_VOLTAGE[MIN] = 0
VM_AC_VOLTAGE_SET Range applied to the AC voltage set-up parameters
Units V
Range of [MIN] 0
Range of [MAX] 0 to 765
Definition
VM_AC_VOLTAGE_SET[MAX] is drive voltage rating dependent. See Table 11-4
VM_AC_VOLTAGE_SET[MIN] = 0
To Next Page
Loading...
