Nieco FH94E - Page 23

23
Model FH94 Electric
III. OPERATION
FH94E
Push Bar Feeder Drive
Clean: Every 4 hours
Feeder Housing Enclosure
Clean: Every 4 hours
1. Pull the release pin.
2. Lift push bar feeder bases up and off.
3. Wash with scrub pad, rinse, and sanitize in
the 3-compartment sink.
DO NOT lift the feeder base by the feeder bar or
the chains. This will damage the feeder base.
REASSEMBLY: Pull the release pin and place
feeder base in position.
Feed End
!
1. Lift and remove.
2. Wash with scrub pad, rinse, and sanitize in
the 3-compartment sink.
REASSEMBLY: Hang feeder housings on brackets.
Feed End
Tools
Tools
3-Compartment Sink
3-Compartment Sink
Scrub Pad
Scrub Pad
Instructions
Instructions
3
4
Cleaning & Disassembly Guide