Nightfox 110R - Using the Nightfox; Basic Operation Steps

8
3. Using the Nighox
1. Remove the lens lter cap from the front of the device. The
lter is to be used during day-me only.
2. Turn the Nighox on by holding the ON buon down for two
seconds, unl the display illuminates.
3. Pick an infrared power level by pressing the IR buon. This will
provide illuminaon to the picture. There are 7 brightness
levels. A higher level will provide a brighter picture but will
deplete the baeries quicker.
4. Focus the picture by turning the lens clockwise or an-
clockwise (see arrow 9 on page 5).
5. You can zoom by pressing the ZOOM buon to magnify the
picture by up to 2x. Keep pressing to go back to 1x
magnicaon.
6. Press the MODE buon to switch modes — the Nighox’s four
modes are Photo, Video, Gallery and Sengs. These are
explained in the next secons.