157
CUSTOM SETTINGS
AND O
THER MENUS—CUST
OM SETTINGS
Using the Function Button to Adjust Custom Settings
If CSM is selected in the Assign FUNC sub-menu, the
button can be used to select the custom settings bank. Keep-
ing the button pressed, rotate the main command dial
until custom setting 0 appears in the rear control panel. The
currently selected bank will be displayed following the custom
settings number. To select a new settings bank, rotate the sub-
command dial while pressing the button. Release the
button to put your selection into effect.
3
Display the Custom Setting Bank menu
Press the multi selector to the right to enter the custom settings menu, then
press the multi selector up or down to highlight F0 Custom Setting Bank.
Press the multi selector to the right to display the menu shown below.
OK
F0 Custom
Setting Bank
Bank A
Bank B
Bank C
Bank D
CSM MENU
4
Choose a custom settings bank
Press the multi selector up or down to highlight the desired settings bank, then
press the multi selector to the right to put your choice into effect and return to
the custom settings menu.
Settings stored in the selected bank will automatically be put into effect when the
bank is chosen. Any changes to custom settings made after the bank is selected will
be saved in the selected bank.
For more information on:
pg. 116 The Assign FUNC sub-menu
To Next Page
Loading...
Need help?
General
