Nikon F 4 - Page 87

1 With maximum aperture faster than f/3.5, use TC-16A
Autofocus Converter. Incompatible with maximum aperture
of f/3.5 or slower.
2 With maximum aperture faster than f/5.6.
3 With maximum effective aperture faster than f/5.6.
4 With shutter speed set to 1/125 sec. or slower. Flash
necessary.
5 Aperture cannot be selected.
6 Exposure determined by presetting lens aperture. Exposure
must also be determined before shifting; in A mode, use
AE-L button before shifting.
7 Shutter should be released, after exposure measurement,
by stopping down PB-6.
8 Use stop-down measurement with Type B, E, K, J, or P
focusing screen.
9 Use full-aperture measurement with maximum aperture of
f/1.8tof/2.8.
10 In Single Servo autofocus mode with lens A-M switch set at
M, shutter is not released unless in-focus indicator lights up
inside viewfider.
11 Focus lock button on TC-16 cannot be used.
12 Stop-down measurement possible. With aperture of f/5.6 or
slower, set exposure compensation dial (or focusing screen
exposure compensation dial for flash photography) to -1.
With 400mm f/5.6 lens, compensate exposure to -1 when
the lens aperture is set at f/8 or slower.
13 For full-aperture measurement, set exposure compensation
dial (or focusing screen exposure compensation dial for
flash photography) to —1.
14 For full-aperture measurement, set exposure compensation
dial to +1.
15 In stop-down measurement, set exposure compensation
dial (or focusing screen exposure compensation dial for
flash photography) to —1.
16 In stop-down measurement, set exposure compensation
dial to +1.
17 Exposure compensation necessary. (See focusing screen's
instruction sheet.)
18 Exposure compensation necessary for full-aperture
measurement. (See footnote 13 or 14.)
19 Exposure compensation necessary for stop-down measure-
ment. (See footnote 15 or 16.)
20 When using the TC-301 with Nikkor 400mm f/2.8, Nikkor
300mm f/2.8 or AF Nikkor 300mm f/2.8 lenses, Matrix
Metering cannot be used.
• The following Nikkor lenses cannot be used with the F4s/F4
camera: All 8mm f/8,16mm f/3.5 (No. 272281 - 290000),
28mm f/3.5 (No. 625611 - 999999), 35mm f/1.4 (No.
385001 - 400000), all 55mm f/1.2, all old-type Reflex
1000mm f/6.3, all 21mm f/4, all old-type PC 35mm f/3.5.
• The AF Teleconverter TC-16 (for F3AF) cannot be attached
to the F4s camera.
• To attach an old-type Reflex-Nikkor 500mm f/8 to an F4s
camera, turn the lens' tripod mounting collar so it faces the
direction opposite the camera's grip (from the front of the
camera, it should face the right-hand side). To change the
camera/lens assembly from horizontal to vertical position or
vise versa, do not turn the assembly; turn the tripod head.