Nikon F3 High-Eyepoint - Page 7

4. Move the power switch ®
to
uncover the red dot ®.
This makes the ca mera ready for
exposure reading and shooting.
5 Touch the shutter release
• button @ lightly.
This activates the exposure meter .
The
meter stays on for 16 seco nds
after you take your finger off the
bu tton and turns itself off auto-
matically to conserve battery power.
6. Check battery power.
Look through the vi ewfinder @
at the liquid crystal disp l ay (LCD).
The
shutter speed should be dis-
played to show that the batteries
have been properly installed and
their power is adequate. If not, re-
place both batteries .
7