Nikon LS-2000 Reference Manual

- 41 -
Using the Scanner: Using the IX240 Film Adapter
✔Cautions
• The latch button will lock when film is fed from the cartridge
into the scanner. Do not attempt to open the latch until the
film has rewound or been ejected as described in “Removing
Film,” immediately below.
• Do not remove the adapter with film inside and the cover
closed. Open the cover and remove the film before replac-
ing the adapter.
• Do not insert undeveloped film in the adapter.
• Do not move the scanner while scanning is in progress.
• The number of times IX240 film can be unwound from the
cartridge is limited. When scanning IX240 film, scan as many
images in a session as possible to minimize the number of
times the film is wound and unwound. If you notice an
unusual noise when scanning IX240 film, remove the film as
described below and take it to a developer to have a copy
made. Use the copy when making further scans.
Removing Film
To remove film from the adapter, click the “eject” button ( )
in the Nikon Scan scan window (see the software reference
manual for your platform). Wait until the scanner’s status LED
glows steadily, then open the cover and take the film out with
your fingers.
Using the SF-200 Slide Feeder
The SF-200 slide feeder, which must be purchased separately, is
used for consecutive scanning of 35 mm slides. The SF-200 is
shown below.
Status LED
Push plate
Load mark
Feed magazine
Ejection
magazine
Push plate
Magazine cover
Slide insertion guide

Nikon LS-2000 Specifications

General

Brand	Nikon
Model	LS-2000
Category	Film scanner
Language	English