Nikon LS-2000 User Manual

13
3. Setup
Nikon LS-2000 35 mm Film Scanner User’s Guide
✔ SCSI connection checklist
• Turn off the computer, the LS-2000, and all SCSI devices before
connecting the scanner.
• Be sure that the devices at both ends of the SCSI chain are
terminated. If the host computer is a Macintosh, the chain will
already be terminated at the computer end. In the case of IBM
PC/AT compatibles in a chain which contains external devices
only, the chain should be terminated at the SCSI board. In the
case of a chain which includes internal devices, you may need to
remove termination from the board and terminate the last
internal device.
• The maximum number of SCSI devices that can be connected in
a single chain is eight, including the computer and any internal
SCSI devices such as hard disks or CD-ROM drives.
• The total length of cabling in the SCSI chain should be no more
than six meters (twenty feet). The longer the cabling, the less
reliable the connection.
Safety Precautions
• Do not damage the SCSI cabling’s protective insulation. Do not
forcibly tug or bend SCSI cables, place cables under heavy
objects or expose them to heat or flame. When disconnecting
cables, handle the cable by the connector, not by the cable itself.
Should the insulation be damaged or the internal wiring exposed,
replace the cable immediately.
• Do not handle SCSI cables or devices when your hands are wet.

Nikon LS-2000 Specifications

General

Brand	Nikon
Model	LS-2000
Category	Film scanner
Language	English