Nikon LS-2000 - Buttons

22
4. Scanning
Nikon LS-2000 35 mm Film Scanner User’s Guide
Step 3—Insert an adapter in the scanner
The LS-2000 comes with separate adapters for scanning mounted 35
mm slides and strips of 35 mm film containing up to six frames each.
Either adapter can be inserted in the scanner while the scanner is on.
Before mounting an adapter in the adapter slot, check that the
scanner’s status LED is glowing steadily. Adapters should not be
inserted or removed while the status LED is blinking. Open the
scanner’s front cover and slide the adapter in as shown in the illustra-
tions below, stopping when the adapter is fully inserted. In the case
of the SA-20, be sure that the connectors on the rear of the adapter
are fully inserted in the connectors at the back of the adapter slot.
Inserting the
MA-20 S
LIDE
MOUNT
ADAPTER