What to do if my Nikon Monarch 7iVR Measuring Instruments device does not turn on?
First, ensure that you press the PWR button located on the top of the device's body. Then, verify that the battery is correctly inserted. If the device still doesn't turn on, replace the battery with a new one.
Why can't I turn off the VR (Vibration Reduction) function on my Nikon Monarch 7iVR Measuring Instruments?
The VR (Vibration Reduction) function activates automatically when the Laser Rangefinder is turned on. It deactivates when the Laser Rangefinder is off. The VR function cannot be manually switched on or off.
What to do if my Nikon Measuring Instruments shows an inability to measure or anomalous result?
First, confirm that each mode setting is correct. Then, check if the device can measure a large target that is close to you, such as a building approximately 15 meters or yards ahead. If the issue persists, clean the lens surface.
How to know if the VR (Vibration Reduction) function is working on Nikon Monarch 7iVR Measuring Instruments?
Compare the vibration of the target in the viewfinder when the Laser Rangefinder is ON and OFF. When the Laser Rangefinder is ON, the VR (Vibration Reduction) function is always activated.
Why are there minute motion sounds when my Nikon Measuring Instruments power turns on and off?
These sounds are normal and are due to the VR (Vibration Reduction) system motor. You can continue to use the Laser Rangefinder without concern.
General| Brand | Nikon |
|---|---|
| Model | Monarch 7iVR |
| Category | Measuring Instruments |
| Language | English |
Warnings and precautions for laser safety, including aiming and eye protection.
Precautions for safe monocular use, battery handling, and disposal.
Cautions on environmental exposure, care, maintenance, and storage.
Instructions for inserting or replacing the battery and checking the level indicator.
How to turn on the device, aim, and press the button to measure distance.
Common problems and their solutions for the rangefinder.
Advice against user repair and disassembly, and contact for service.
To Next Page