Nikon Nikkormar FT3 - Changing the Lens

CHANGING THE LENS
To remove the lens from the camera, press the lens
release
button on the front of the camera body and
twist the lens to the right as far as it will go. The
lens will come loose
and can be lifted out easily ~
Mounting lenses fitted with a meter coupling ridge:
Before
mounting the lens, check that the meter
coupling lever on the camera is down; if not, push the
lever
down into place.
Position the lens in the moun t, aligning the moun ting
indexes on the lens
and camera body. Twist the lens
counterclockwise until it clicks into place. These
steps provide
for full mounting of the lens, while
simultaneously indexing the lens' maximum aperture
setting to the camera.
Mounting lenses without a meter coupling ridge:
Depress the coupling lever release, and
push the meter
coupling lever up. Then mount the lens and lock into
position as explained previously. For operation with
lenses not fitted with a meter coupling ridge, stop-
down measurement (as described on page 15) is
required.
27