19
En
The Final Check
This section describes how to perform a pre-dive check after attach-
ing the SB-N10. For information on performing pre-dive checks on
the Nikon1 AW1 or a waterproof case, see the manuals provided
with the camera or case.
After completing the checklist on page
18 and con rming that the battery hold-
er is securely inserted and latched, ll
a bucket or other container with fresh
water, immerse the assembly, and con-
rm that no air escapes. Should you
notice air escaping, immediately re-
move the assembly from the water, dry
it thoroughly, and check the watertight seals. If the cause of the
leak can not be determined, contact a Nikon-authorized service
representative.
To Next Page
Loading...
Need help?
General
