1
Mac
Updating Camera Firmware
–Mac–
Thank you for choosing a Nikon product. This guide describes how to perform this rmware
update. If you are not condent that you can perform the update successfully, the update can
be performed by a Nikon service representative.
See the camera manual for information on camera operations.
Important
The camera may be damaged if power is interrupted or camera controls are operated during
the update. Do not turn the camera o, remove or disconnect the power source, or operate
camera controls during the update. If the update is not completed successfully and the
camera becomes inoperable, take the camera to a Nikon-authorized service representative
for inspection.
1
Get ready
To upgrade the camera rmware, you will need:
• The camera
• A computer equipped with a card reader or card slot
• One of the following camera power sources:
— An AC adapter
— A battery or batteries with sucient charge to complete the update
• A Nikon-approved memory card that has been formatted in the camera (note
that all data on the memory card will be deleted when the card is formatted;
before formatting the card, back up any data you wish to keep to a computer
or other device)
• The camera User’s Manual
To Next Page
Need help?
General
