Nikon WR-1 Quick Start Guide

1
Mac
Updating the Firmware for WR-1/WR-R10
Wireless Remote Controllers
–Mac–
Thank you for choosing a Nikon product. This guide describes how to update the rmware
for WR-1 and WR-R10 wireless remote controllers. If you are not condent that you can
perform the update successfully, the update can be performed by a Nikon-authorized service
representative.
See the manual provided with your Nikon product for information on use.
Important
The product may be damaged if power is interrupted or the controls are operated during
the update. Do not turn the product o, remove or disconnect the power source, or attempt
to operate the product during the update. If the update is not completed successfully and
the product becomes inoperable, take it to a Nikon-authorized service representative for
inspection.
1
Get ready
To perform the update, you will need:
• Either
— A WR-1 wireless remote controller and supplied cable (either a ten-pin or
accessory terminal cable, depending on the camera) or
— A WR-R10 wireless remote controller (if the camera is equipped with a ten-
pin terminal, you will also require a WR-A10 WR adapter)
• A camera that can be used to update the wireless remote controller rmware
(a D7100 is used in this guide for illustrative purposes)
• A computer equipped with a card reader or card slot
• One of the following camera power sources:
— An AC adapter
— A fully-charged battery
• A Nikon-approved memory card that has been formatted in the camera (note
that all data on the memory card will be deleted when the card is formatted;
before formatting the card, back up any data you wish to keep to a computer
or other device)
• The manuals for the camera and wireless remote controller

Nikon WR-1 Specifications

General

Brand	Nikon
Model	WR-1
Category	Remote Control
Language	English