Nikon Z6III - Parts Removal and Replacement Procedures; Before Disassembling the Product; During the Repairing

23
Parts Removal and Replace-
ment Procedures
Before disassembling the Product
IMPORTANT
● As for the Product powered on by the power switch, before disas-
sembling the Product, be sure to check that the Product is pow-
ered o󰀨 and that the battery has been removed.
● Check that all the lenses, camera, and accessories attached to
the Product are removed before disassembling the Product.
● Always cover the workbench's surface with a soft, non-scratch
material suitable for ESD protection.
● Frequently clean the surfaces you use to work and keep them free
of debris/abrasive particles.
● Always follow the work steps described in each process section.
During the repairing
IMPORTANT
● If there is this kind of indication, apply the specied grease or
adhesive by a small brush.
Example:
MDF-1173SMDF-1173S
AX-125AX-125
● If there is a specied torque, use an appropriate torque driver for
tightening screw.
Example: 0.1 N• m
● If the parts are associated with circled numbers, please work in
that numerical order.
Example: ①②③ means to work in the order of ① to ③.
● Do not pinch FPCs or cords during reassembly.
● Be careful not to damage or lose parts.