Nikon Z6III - Page 8

5
Repair-specic precautions and warnings
● As for the Product powered on by the power switch, before disassembling the Product, en-
sure that the Product is powered off and that the battery has been removed.
● As a safety measure, we recommend that you wear protective eyewear when disassem-
bling or reassembling the Product.
● Always check the following points before and while disassembling the Product.
– Wear an anti-static wrist strap.
– The work area is appropriately grounded, and an environment in which electrostatic
discharge (ESD) has been provided with safety measures is ensured.
● Before starting work, check that you are following the general guidelines and ESD compliance
steps. For details, refer to "Before disassembling the Product'' on page 23.
● When removing any parts from the Product, place all the attached parts and screws away from
the work area to prevent the Product and parts from being damaged or lost.
Safety policy and procedure
● All Product safety issues must be managed according to the following points.
● If any of the following conditions are visible, stop repairing the Product and contact Nikon's
customer service at www.nikonproductsupport.com.
– There are burnt or melted components or traces on the outside of the Product, or other
heat-related damage (including scorching on charging terminals or other connection
terminals).
– The Product has burnt or melted parts or traces on the inside, or contains damage from
overheating.
– Products that appear to have problems such as having been forcibly detached or
disassembled for reasons other than misuse by the user or unauthorized repair (those that
have been damaged by being subjected to an impact due to dropping, those that have
evidence of tampering, or those with damage or separation caused by dilatation of the
battery).
– Plastic parts with sharp edges that may pose an injury risk to the user.
● When contacting Nikon's customer service, please have the following information ready to
enable us to check the situation:
– Model, model number, and serial number of the a󰀨ected Nikon Product and any third-party
product used together with the Nikon Product, if any.
– Description of the damage found.
– Clear photos that show the damage.