To Next PageTo Next Page
Need help?Do you have a question about the Niles SSVC-2 and is the answer not in the manual?
General| Type | Speaker Selector |
|---|---|
| Channels | 2 |
| Number of Zones | 2 |
| Impedance Protection | Yes |
| Frequency Response | 20 Hz - 20 kHz |
| Signal-to-Noise Ratio | > 90 dB |
| Total Harmonic Distortion | < 0.1% |
| Power Supply | Not required |
Overview of the SSVC series speaker selection and volume control systems.
Details the continuous music power rating of 100 watts per channel.
Specifies the frequency range of +/- 1.2 dB from 20 Hz to 20 kHz.
Indicates the unit is designed as a table-top component.
Details the need for 2-conductor speaker wire and connector gauge compatibility.
Provides the physical dimensions of the unit: 8-1/2" wide x 2" high x 7-1/4" deep.
States the product's weight as 3 lb.
Warns against using the SSVC series with amplifiers exceeding 100 watts per channel RMS at 8 ohms to prevent warranty voidance.
Explains how connecting multiple speaker pairs affects impedance and recommends caution below 4 ohms.
Provides numbered steps for turning on, selecting speakers, adjusting volume, and turning off the SSVC system.
Recommends 16 or 18 gauge stranded copper wire, with 14 gauge for longer runs, and specifies fire-rated wire for in-wall use.
Advises routing speaker wires away from electrical devices like dimmers to prevent noise.
Details the procedure for connecting speaker wires to the SSVC-2 model's removable connector plug.
Guides the installation of speaker wires into the SSVC-4/6's removable connector plugs and securing them.
Explains how to set the impedance magnification switch based on the number of speaker pairs connected.
Explains that the receiver/amplifier volume acts as the master control for all connected speaker pairs.
Details how the SSVC series volume controls allow independent adjustment of each speaker pair's volume.
Highlights 100W/channel RMS power handling and selectable impedance magnification for multiple speaker pairs.
Notes individual room on/off switches and 12-step, 54dB maximum volume attenuation.
Mentions separate ground paths for all amplifiers and screwless connectors for up to 14 gauge wire.
Describes rugged metal chassis, non-skid feet for stability, and adhesive-backed room labels.
States a ten-year limited warranty and lists dimensions for SSVC-2, SSVC-4, and SSVC-6 models.
Provides shipping weight details for SSVC-2, SSVC-4, and SSVC-6 models.
