Need help?Do you have a question about the Niles SVL-4 and is the answer not in the manual?
General| Brand | Niles |
|---|---|
| Model | SVL-4 |
| Category | Recording Equipment |
| Language | English |
The SVL-4 is a speaker selector and volume controller for four pairs of speakers, offering independent volume adjustment and protection.
Details improvements over other controllers, including 12-position volume, dynamic range, pop-free switching, and compatibility.
Specifies maximum power output (100W/channel at 8 ohms) and warning against higher power receivers.
Explains how connecting multiple speaker pairs affects impedance and the risks below 4 ohms.
Recommends 16 or 18 gauge wire, 14 gauge for longer runs, and warns against using wire larger than 14 gauge.
Advises keeping speaker wires away from electrical devices to prevent noise.
Explains the need for a continuous load for tube amps and suggests a resistor solution.
Instructions to select a convenient location and run necessary wiring, referencing diagrams.
Details on stripping wires, connecting terminals, and ensuring proper phasing for audio signals.
Instructions to affix pre-printed room labels to ON/OFF selector buttons for clarity.
Step-by-step guide for operating the SVL-4 with one speaker pair at a time.
Explains how to play multiple pairs simultaneously and the function of the PROTECTION button.
Explains the manual override for the protection circuit located on the rear panel.
Describes how SVL-4's individual controls allow fine-tuning of each speaker pair's volume.
Lists power handling, frequency response, dimensions, and weight of the SVL-4.
To Next Page
