Nilfisk-Advance Advance SC400 User Manual

Nilfisk-Advance A/S
Sognevej 25
DK-2605 Brøndby
Denmark
Tel.: +45 43 23 40 50
Fax: +45 43 43 77 00
mail.com@nilfisk-advance.com
www.nilfisk.com
ATTENTION! Do not use the machine before you have read and understood the User Manual
The machine
doesn’t work
as it should?
The suction
doesn’t work
as it should?
The machine
doesn’t clean
as it should?
The brush
don’t work as they
should?
TROUBLESHOOTING
SC400
1 Check if the power cable is correctly
connected.
1 Check if the suction hose is
correctly installed and cleaned.
1 Check if you have the right water
settings.
1 Check if the brush are correctly in-
stalled and not worn out.
2 Check if the battery is charged.
2 Open the recovery tank and check
if the vacuum grid and gasket are
cleaned.
2 Check if the solution tap is open.
2 Check if there isn’t any brush motor
overload i.e. 3 battery Ledsflash si-
multaneously.
3 Check if squeegee blades are
damaged or dirty.
3 Check if there are external materials
avoiding brush rotating.
4 Close the recovery tank cover prop-
erly and/or verify the gasket wear.
3 Check if the solution filter is
cleaned.
All manuals and user guides at all-guides.com

Nilfisk-Advance Advance SC400 Specifications

General

Brand	Nilfisk-Advance
Model	Advance SC400
Category	Scrubber
Language	English