7
TROUBLE SHOOTING
PROBLEM CAUSE REMEDY
This Vacuum cleaner is approved the following
DJ68-00085P REV
(
0.0
)
CARING THE Pet Brush turbine
(GM 100 Sprint Plus Pet Pack model only)
slots
Open the cover. Push up the
both sides of cover. Lift it
upwards and detach it.
After cleaning the turbine, reposition it into its’ own
place. It cannot be reassembled if the ends of tur-
bine are reversed. If you washing the turbine, it
should be dried thoroughly.
To reattach the cover, align hinges of cover with
slots on the inner sides of nozzle. After aligning,
press the both sides of cover.
Smart Protector (transparent turbine)
(GM 100 Sprint Plus model only)
Transparent tube prevent the tube and hose from
being clogged by obstacle like as socks and clothes.
When transparent tube is clogged.
Separate the nozzle from the tube. Remove the alien
substance with a stick from it. After cleaning it,
reassemble the nozzle to the tube.
Motor does not start.
Suction force is gradually
decreasing.
Cord does not rewind fully.
No power supply.
Filter, nozzle or suction
hose or tube is blocked.
Check that the cord is not
twisted or wound unevenly.
Check cable, plug and
socket.
Remove the object.
Pull the cord out 2~3m &
push down the cord rewind
button.
DJ68-00085P 1/16/02 11:52 AM Page 8
To Previous Page
Loading...
