Safety instructions
SM_MC 9P_MC 10P Ver.1.0_February_2023
6
A
¨
Before starting the VHPW
Go to page 22, machine data and look up the VHPW model you
are about to use. The info provided there will assist you when
reading through this manual.
Prior to beginning work, all equipment must be inspected to
ensure that it is in safe working condition.
Safety valve and Unloader valve: Check that tamper evident
sealings are unbroken to verify that adjustments are
correct.
MC 10P 800/1100 ONLY: Rupture disc device: Check that tamper
evident sealing on rupture disc device is unbroken.
High pressure hose line: Check daily for visual damage.
Do not use high pressure hoses with kinks, compressed areas or
other kind of defect to connectors, threads or O-rings. Do not use
high pressure hoses if the metal wire layer of the hose is exposed
or if the hose has any other defects that can be identied
visually.
MC 10P 800/1100 ONLY: Verify that the hose connector safety
device in both ends of the hose is correctly secured to the
hose and has no damages. (See Page 17 Hose Type guide for
info on correct mounting of the connection safety device).
Verify the high pressure hose and the spraying device with
accessories is suitable for the maximum operating pressure
indicated on Page 17 Hose Type Guide. Replacement hoses must
always follow the demands set in Table on Page 17;Hose Type Guide.
Always place the high pressure hose in such a way that vehicles
cannot drive over it.
To Next Page