Safety instructions
SM_MC 9P_MC 10P Ver.1.0_February_2023
7
A
Spraying device: Check daily for visual damage that could impair pressure integrity.
Handle and store the spraying device in such a way that it will not
get large mechanical shock (e.g. falling onto a concrete oor).
MC 10P 800/1100 ONLY:
Inspect the dump gun cartridge assembly after each use and
lubricate. Also inspect prior to use if there is doubt about last
inspection. Failing to clean or replace cartridge can cause a
malfunction. See Page 65-66 Dump gun maintenance” for detailed
guidance.
Nozzle: Verify that the nozzle size and attachment to nozzle
tting is correct. (See Page 67 Nozzle Type Guide) Verify there is
no damage near the nozzle outlet hole.
Main power cable: Verify the outer shielding of the cable is intact.
Always place the main power cable in such a way that vehicles
cannot drive over it.
Personal Protection Equipment (PPE): For PPE there are different
demands set by local Working Environment Authorities depending
on your location. These demands must be complied
with at all times. However due to the force of the VHPW
machines, Nilsk recommends the PPE mentioned in
Page 20-21 to be worn by both the VHPW trigger gun
operator and the 2nd supporting operator for optimal
protection.
To Next Page