Nilfisk-Advance MH 3M Service Manual

SM_MH 3M_4M Ver.1.2_May 2016
Safety instructions
4
A
For your own safety
ESD measures
(electrostatic discharge)
Observe valid safety regulations
for electrical equipment. In
particular, observe the following
regulations:
IEC 60335-2-79
EN 60335-2-79
Additionally:
Also see national regulations
Before using the cleaner, always
read the operating instructions
and keep them readily available.
Only allow the high pressure
Repair work should be carried
out by persons instructed in
electrical installations or by
trained electricians only.
Take the following ESD precautions before carrying out any
repairs to the electronics:
 Touch the earth conductor before repairing the cleaner
( to discharge electrostatic charge from your body ).
 Wear wrist band if necassary.
 Use a conductive floor covering or a conductive table cover.
 Never touch the printed circuit board or electronic components
( always hold on to plastic ).
 Transport electronic components in conductive packaging
( e.g. ESD bag ).

Nilfisk-Advance MH 3M Specifications

General

Model	MH 3M
Category	Pressure Washer
Max Pressure	150 bar
Pump Pressure	150 bar
Motor Power	3 kW
Power Consumption	3 kW
Voltage	400 V
Frequency	50 Hz
Max. inlet temperature	60 °C
Pump (RPM)	1450 RPM
Electric cable	5 m
Voltage/phase/frequency	400 V / 3 / 50 Hz