ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual
The machine
doesn’t work
as it should?
The suction
doesn’t work
as it should?
The machine
doesn’t clean
as it should?
The brushes
don’t work as they
should?
TROUBLESHOOTING
SC500
1 Check if the power cable is correctly
connected.
1 Check if the suction hose is
correctly installed and cleaned.
1 Check if you have the right
detergent and water settings.
3 Check if the brush are correctly in-
stalled and not worn out or if there
are external materials avoiding brush
rotating.
2 Check if the battery is charged.
2 Open the recovery tank and check
the debris tray and float are clean
and working.
2 Check if the solution valve is open.
2 Check if there isn’t any brush motor
overload “WARNING ALARM F2”
on the display.
3 Restart the machine without press-
ing the paddle.
3 Check if squeegee blades are dam-
aged or dirty.
3 Check if the solution filter is
cleaned.
1 To adjust machine direction turn
front knob until machine is working
straight.
4 Check floor inclination is not exeed-
ing specifications.
4 Check the lid gasket is in good
and working condition and sealing
when lid is closed.
4 Check the EcoFlex™ system is
cleaned, eventually purge the sys-
tem.
To Previous Page
Loading...
Need help?
General
