Nilfisk-Advance SR 1300H B

Questions and Answers

C
Caleb StevensAug 16, 2025
Why is my Nilfisk-Advance Blower not picking up debris?
- D
  donnakellyAug 16, 2025
  If your Nilfisk-Advance Blower isn't picking up debris or dust effectively, several factors could be at play. The dust filter might be clogged, so try cleaning it using the filter shaker or by disassembling it. Also, check if the hopper is full and empty it if necessary. Ensure the skirts are properly adjusted or replace them if they are broken. Lastly, make sure the brooms are correctly adjusted in height.
J
John HarmonAug 22, 2025
How to fix a Nilfisk-Advance SR 1300H B Blower that won't turn on?
- G
  gloverjeremyAug 22, 2025
  If the display on your Nilfisk-Advance Blower doesn't turn on and the machine doesn't operate when you turn the ignition key to "I", it could be due to a disconnected battery connector or an open fuse. First, check and connect the battery connector. Then, inspect the F1 and/or F0 fuses to see if they are open and replace them if needed.
W
Warren FrazierAug 26, 2025
Why does my Nilfisk-Advance Blower battery die so quickly?
- B
  Brittney SmithAug 26, 2025
  If you're experiencing low battery life with your Nilfisk-Advance Blower, the batteries may no longer be efficient. Consider replacing the batteries. If needed, install batteries with a higher capacity.
M
masonsarahAug 28, 2025
What to do if the main broom on my Nilfisk-Advance Blower isn't working?
- D
  Donald BairdAug 28, 2025
  If the main broom on your Nilfisk-Advance Blower isn't working, the circuit breaker might be open. Allow the main broom motor to cool down, then reset the circuit breaker by pressing the relevant push-button.
B
Benjamin ShawAug 31, 2025
Why is the filter shaker not working on my Nilfisk-Advance SR 1300H B Blower?
- S
  Stacy DavisAug 31, 2025
  If the filter shaker on your Nilfisk-Advance Blower isn't working, it could be because the main broom is not lifted or the F4 fuse is open. Ensure you lift the main broom before using the filter shaker. If the issue persists, replace the F4 fuse.
S
Samantha HernandezSep 3, 2025
What to do if my Nilfisk-Advance SR 1300H B Blower won't move?
- B
  Barry CampbellSep 3, 2025
  If your Nilfisk-Advance Blower doesn't move when you press the forward/reverse gear pedal, it might be because the pedal was pressed while turning the ignition key to "I". Turn the ignition key to "0" and then to "I", and make sure not to press the forward/reverse gear pedal during this process.
M
Melinda HaleSep 6, 2025
Why aren't the side brooms working on my Nilfisk-Advance Blower?
- N
  Nathan MartinezSep 6, 2025
  If the side brooms on your Nilfisk-Advance Blower aren't operating, the right or left side broom circuit breaker might be open. Allow the side broom motor to cool down, then reset the circuit breaker by pressing the relevant push-button.
M
Michele DunnSep 9, 2025
What causes a Nilfisk-Advance Blower hopper to not dump?
- K
  Kenneth PaulSep 9, 2025
  If the hopper on your Nilfisk-Advance Blower isn't dumping, the F3 fuse may be open, or the hopper is too low. Replace the F3 fuse. Also, lift the hopper to a minimum height of 300 mm.
C
Christina DixonSep 10, 2025
What to do if Nilfisk-Advance SR 1300H B Blower only works when stationary?
- S
  Scott LucasSep 12, 2025
  If your Nilfisk-Advance Blower shuts off and the red warning light flashes when it's moving, but works fine when stationary, the batteries may be discharged. Try charging the batteries. If the problem continues after charging, you may need to replace the batteries.
J
Jermaine MercadoSep 12, 2025
Why won't the hopper lift on my Nilfisk-Advance SR 1300H B Blower?
- R
  Ryan SmithSep 12, 2025
  If the hopper on your Nilfisk-Advance Blower isn't lifting, the F2 fuse might be open. Replace the F2 fuse to resolve this issue.