2
1
3
2.2 Mounting base
If the base is uneven height adjustments may be made by adjusting the counter nut (1) on the
machine foot (2) as shown on Fig. 1.
It is important that the plant is adjusted to horizontal position. Otherwise it may be a problem
opening the cabinet door.
Fig. 1
It is advisable to fix the module frame of the system to both the bulk-
head and bottom when mounting the system in ships.
The tip over safety devices (3) (which are available as an accessory) should be placed diagonally
on the plant and mounted between the machine feet and the floor stands as shown on Fig. 2.
Fasten the fittings securely to the floor with 4 pcs. ∅8 mm hexagon-headed screws complete
with expansion bushes or with 4 anchors of the impact type.
Fig. 2
To Next Page
Loading...
Need help?
General
