7
1)
Options / model variants
Original instructions
NEPTUNE 5 FA
3.7 Fill up fuel tank
With the machine cold, turned
off and disconnected from power
supply:
1. Fill fuel tank from a clean con-
tainer with a fresh fuel (fuel oil
EL, or Diesel oil DIN 51 603),
or fuel type recommended by
your distributor.
The fuel must be free from con-
tamination.
Tank capacity see chapter 9.4
Technical data.
months it is recommended that
a fuel conditioner/stabilizer be
added (available from the fuel
oil trade).
3.8 Connecting the high
pressure hose
3.8.1 Machines with high
pressure hose reel
1)
1. Connect the high pressure
hose quick connector to the
high pressure nipple (A) lo-
cated at the hose reel axle.
2. Place the high pressure hose
into the hose guide (B) and
ritain it with the clip.
3. Release the brake (C) on the
hose reel and wind up the
high pressure hose.
3.8.2 Machines without high
pressure hose reel
1. Connect the high pressure
hose quick connector to the
high pressure nipple located
at right rear of machine above
chemical tank.
A
B
C
NOTE!
At temperatures below 8°C
(46°F), the fuel oil begins to so-
lidify (paraffi n precipitation). This
can lead to diffi culties in starting
the burner. Before the winter
To Next Page
Loading...
Need help?
General
