38
EN
4.2.2 Switching on the
washer when it is
connected to open
tanks (suction mode)
1. Before connecting the deter-
gent intake set to the wash-
er, fi ll the hose with water.
2. Turn main switch to position
»I«.
3. Unlock the spray handle and
activate it.
Max. suction height = 0 m.
4 Operation
4.1 Connecting the spray
lance to the spray
handle
1. Pull the blue quick-release
grip (A) of the psry handle
forwards and lock it by turn-
ing it to the left.
2. Insert the nipple of the spray
lance (C) into the quick-re-
lease connection and turn
the blue quick-relese grip to
the right (B).
3. Pull the psray lance (or
other accessory) forwards to
check that it is securely at-
tached to the spray handle.
4.2 Switching on the washer
4.2.1 Switching on the washer
when it is connected to a
water supply
1. Main switch
Turn the switch to position
»I«.
2. Unlock the spray handle and
activate it.
3. Lock the spray handle even
during short pauses.
The washer switches off auto-
matically after the spray handle
has been closed. To start the
washer again, activate the
spray handle.
NOTE!
Operate the spray handle se-
veral times at short intervals to
vent the system.
3.4 Electrical connection
1. Observe safety instructions
in chapter 1.
2. Put the plug into the electri-
cal socket.
NOTE!
Always remove any dirt from
the nipple before connecting
the spray lance to the spray
handle.
A
B
C
To Next Page
Loading...
Need help?
General
