E
Troubleshooting
sm_POSEIDON 3_en_Ver.1.0_11.07
27
Fig. E.1:Troubleshooting 1
Fault Cause Remedy
Pressure drop
- Air in the system.
- High pressure nozzle
blocked / worn.
- Pressure control on the
spray lance is not set
correctly.
- Detergent container empty.
- Water inlet temperature
too high.
• Vent the system by
operating the spray gun
several times at short
intervals .If necessarly
operate the cleaner for a
short time without the
High pressure hose
connected.
• Clean / replace the high
pressure nozzle.
• Set the required working
pressure.
• Change container or close
detergent valve.
• See technical data part ”B”.
Pressure
fluctuations
- Lack of water
- Water inlet hose is too long
or its cross-section too
small.
- Lack of water caused by
blocked water filter.
- Lack of water because
max. permissible suction
height has not been
heeded.
- Pump sucks in air
(suction mode)
• Open water tap.
• Use specified water inlet
hose(Refer to user manual).
• Clean the water filter in the
water connection.
(Never work without water
filter).
• See technical data part ”B”
• Check that the suction set
is air tight.
The motor does not start when
the cleaner is switced on.
- The plug is not inserted
properly, i.e. there is no
current.
- The main fuse is switced off.
- Control piston stuck
• Check the plug, lead and
switch.
If necessary have them
replaced by a trained
electrician.
• Switch on the main fuse.
• Get hold of Service Techni-
cian.
To Next Page
Loading...
Need help?
General
