POSEIDON 4
9
1)
Options / model variants
Original instructions
Important safety instructions
For your own safety
Before using the high-pressure
cleaner, be sure to also read the
enclosed operating instructions
and keep them within reach at
all times.
The appliance must
– only be used by persons,
who have been instructed in
its correct usage and expli-
citly commissioned with the
task of operating it
– only be operated under su-
pervision
– not be used by children
General
Use of the high-pressure clean-
er is subject to the applicable lo-
cal regulations.
Besides the operating instruc-
tions and the binding accident
prevention regulations valid in
the country of use, observe rec-
ognised regulations for safety
and proper use.
Do not use any unsafe work
techniques.
Transport
Transport of the high-pressure
cleaner is easy on its large
wheels.
For safe transport in and on ve-
hicles we recommend to prevent
the equipment from sliding and
tilting by fixing it with belts.
Transport (when tilted):
– do not tilt the machine on the
front with the water connec-
tions.
Before starting the cleaner
Before using the cleaner for the
first time, check it carefully to
detect any faults or damage.
In the event of any damage con-
tact your Nilfisk-Alto dealer im-
mediately.
If your 3-phase cleaner was
supplied without a plug, have
it fitted with a suitable 3-phase
plug with earth conductor, by an
electrician.
CAUTION!
Before connecting devices with
voltage changeover: Check that
the pre-selected voltage on the
machine corresponds with the
voltage of the electrical instal-
lation. Otherwise the electrical
devices of the machine can be
destroyed.
Do not connect the cleaner di-
rectly to the public drinking-wa-
ter mains. A connection is per-
mitted, however:
– briefly to a pipe interrupter
with moving section
– with a free outlet
In the case of poor water quality
(sand, etc.), we recommend that
a fine water filter is fitted in the
water inlet.
We recommend the use of a
textile-reinforced water hose
with a nominal diameter of min.
3/4" (19 mm). Before use, check
that the high-pressure cleaner is
safe and in proper condition.
Regularly check whether the
power cord is damaged or shows
signs of ageing.
Use the high-pressure cleaner
only when the mains power lead
is in a safe condition. (risk of
electric shock if damaged!).
Check the rated voltage of the
high-pressure cleaner before
connecting it to the mains power
supply. Ensure that the voltage
shown on the rating plate corre-
sponds to the voltage of the lo-
cal mains power supply.
We strongly recommend that the
power supply to the high pres-
sure cleaner be connected via a
residual current circuit breaker.
This device stops the supply
of electricity if the leakage cur-
rent to earth exceeds 30 mA for
30 ms or it has an earth tester
circuit.
Operate the cleaner only in an
upright position!
Please observe the regulations
and provisions applicable in
your country. Before putting the
high-pressure cleaner into serv-
ice, carry out a visual check of
all the major components.
CAUTION!
High-pressure water jets can be
dangerous if misused. The jet
must not be directed at persons,
animals, live electrical equip-
ment or the cleaner itself.
Wear appropriate
protective cloth-
ing and eye pro-
tectors.
Do not direct the
jet towards your-
self or towards
other persons
in order to clean
clothes or footwear.
During operation of the cleaner,
recoil forces are produced at the
spraying device and, when the
spray lance is held at an angle,
a torque is also created. The
spraying device must therefore
be held firmly in both hands.
Do not use the cleaner when
other people without protective
clothing are in the working area.
Check that cleaning will not re-
sult in dangerous substances
(e.g. asbestos, oil) being washed
off the object to be cleaned and
harming the environment.
Nilfisk-ALTO No. 301003191
To Next Page
Loading...
Need help?
General
