8
Function Description
Figure 3
1. Power Switch 2.embers Adjuster 3. Flame Adjuster
4．Remote/Manual Shift Switch 5.Temperature Adjuster
Once the unit has been properly connected to a ground electrical outlet, it is
ready to operate.
1. Turn the Power Switch to position “I”，you will hear two tweets buzzer，the
fireplace is connected to power supply and ready for operating; Turn the
Power Switch to position “ O” ,the fireplace is disconnected and stop
working.
2. Turn the Remote/Manual Switch to position “I”，you will operate the fireplace
by Manual, not by remote; Turn the Remote/Manual Switch to position
“ O” ,the fireplace can only be operated by remote control.
3. When the Power Switch and Remote/Manual Switch on position“ I” ，you can
adjust carbon bed light shade through operating the embers Adjuster；Adjust
the flame through the Flame adjuster, and adjust the Temperature adjuster
to set your expected temperature.
4. When Power Switch to the position “ I” ，and Remote/Manual Switch to
position “ O” ，you can only operate the fireplace with remote control，
Note:The effective range of the remote control is up to approximarly 6 meters.
To Next Page
Loading...