Ninja BL770 series User Manual

8
www.ninjakitchen.com
Fig. 3b
Fig. 2
Fig. 1
AssemblyandUseforthe72oz.Pitcher
IMPORTANT: Make sure that the motor base
is plugged in for use.
1 Place the motor base on a clean, dry, level
surface such as a counter or table top.
2 Align and lower the Pitcher onto the motor
base. (Fig. 1) Handle should be aligned slightly
to the right of the “LOCK” symbol on the
motor base.
3 Rotate the pitcher clockwise as far as it will go
to lock in place. (Fig.2)
4 The pitcher can be placed on the motor base
two ways; the handle can be on the front right
corner or the front left corner.
(Fig.3a,Fig.3b)
5 Holding the 6-Blade Assembly by the top of the
shaft, place it onto the drive gear inside the
pitcher. Ensure that the attachment is seated
properly and is standing upright. (Fig.4)
NOTE: The blade will fit loosely on the drive
gear.
6 Add the ingredients to the pitcher, making sure
that they do not exceed the highest measured
marking line on the side of the pitcher.
NOTE: If you need to add additional ingredients
while the appliance is processing, open the
pour spout cap and pour the ingredients in
through the opening.
7 Plug the power cord into the electrical outlet
and press the power button (
).
NOTE:Asasafetyfeature,thepower
button(
)willashandthemotorwillnot
workifthepitcherandlidarenotinstalled
correctly.Whenthepitcherandlidare
installedproperly,thepowerbutton(
)
willbesolid,indicatingthattheappliance
isreadyforuse.
8 Holding the lid by the handle in the upright
position, place it on top of the pitcher aligning
the arrow (
) located on the lid with the arrow
(
) located on the pitcher’s handle. (Fig. 5)
Press the handle down until you hear a click.
Fig. 4
Fig. 5
Assembly
Fig. 3a
BL770_series_30_IB_ENG_120627_3.indd 8 12-06-27 11:55 AM

Ninja BL770 series Specifications

General

Brand	Ninja
Model	BL770 series
Category	Blender
Language	English