PREPARING & USING
THE NINJA
HOT & COLD BREWED SYSTEM™
SIGNATURE BREW
SPECIALTY BREW
1 After filling the water reservoir,
insert either the COFFEE or TEA
filter holder into the brew basket.
Add the ground coee, loose leaf
tea, or tea bags to the filter.
2 Close the brew basket, ensuring
it is securely in place. The control
panel will display either COFFEE
(Fig. 15a) or TEA (Fig. 15b) settings
based on the filter holder that has
been inserted.
3 Place the empty vessel you would like
to brew into under the brew basket.
4 Turn the START/SELECT dial to
choose SPECIALTY (Fig. 18). If
brewing tea, press the Tea button
to toggle to the tea menu, and
use the dial to choose your tea
type. To change your brew style
while in the tea menu, press the
Tea button
again.
5 Press the START/SELECT dial to
start the brew. A progress bar on the
control panel will show the status
of the brewing cycle. To cancel the
brew at any time, press the dial again
or press the Power button.
6 The unit will beep and the clock
will display End when the brew
is complete.
SETTING THE DELAY BREW
1 Turn the unit on by pressing the
Power button.
2 After filling the water reservoir and
adding ground coee or tea to the
correct filter holder, be sure the
reservoir, brew basket, and filter
are securely in place. Place the
appropriate-size vessel under
brew basket.
NOTE: The brewing cycle will begin,
then pause for a short period before
resuming. This process is used to evenly
saturate the coee grounds or tea.
NOTE: Specialty always yields 4 oz.
of coee and 6 oz. of tea (with the
exception of Green tea, which
yields 2 oz.).
NOTE: The unit must remain on for the
Delay Brew function to work. DO NOT
power o after setting Delay Brew.
NOTE: If brewing an iced blended
drink, fill the desired vessel with the
amount of ice recommended in the
recipe before brewing.
NOTE: The clock will remain on even if
the unit is turned o. Ensure the unit is
powered on to set Delay Brew.
3 Fill your desired vessel to the top with
ice cubes and place the vessel below
the brew basket. Use the Multi-Serve
dial to select the brew size.
4 Turn the START/SELECT dial to
choose either Over Ice Brew or Cold
Brew (Fig. 17a, Fig. 17b). If brewing
tea, press the Tea button
to toggle
to the tea menu, and use the dial to
choose your tea type. To change your
brew style while in the tea menu,
press the Tea button
.
5 Press the START/SELECT dial to
start the brew. A progress bar on the
control panel will show the status of
the brewing cycle. To cancel the brew
at any time, press the dial again or
press the Power button.
6 The unit will beep and the clock will
display End when the brew is complete.
OVER ICE BREW & COLD BREW
NOTE: Glassware may be used
with the Cold Brew setting, but
not the Over Ice Brew setting.
1 After filling the water reservoir,
insert either the COFFEE or TEA
filter holder into the brew basket.
Add the ground coee, loose leaf
tea, or tea bags to the filter.
2 Close the brew basket, ensuring
it is securely in place. The control
panel will display either COFFEE
(Fig. 15a) or TEA (Fig. 15b)
settings based on the filter holder
that has been inserted.
PREPARING & USING
THE NINJA
HOT & COLD BREWED SYSTEM™
NOTE: For COLD BREW coee ONLY,
add an additional scoop of coee
grounds to the brew basket.
NOTE: Cold Brew takes about 15
minutes for a Full Carafe.
Fig. 17a Fig. 17b Fig. 18
To Next Page
Loading...
Need help?
General
